19
ChadEdit User Guide
•
USR-5 not connected or not responding
. You can click on the
Details >>
button to open a window listing all the serial ports on
your PC.
•
If another application is using the serial port to which your USR-
5 is connected you can either try another serial port or have the
other application release the serial port.
•
If ChadEdit could open the serial port to which your USR-5 is
connected but still could not connect, check to see if both ends of
the cable are properly inserted and if USR-5’s batteries have not
run out. Then wait a few seconds and try again. If after a number
of tries ChadEdit still cannot connect, try resetting your USR-5,
wait until it beeps twice and try again.
See
How do I create a macro?
for information on how to assign more than a single IR code to a button.
How do I assign an IR code to a direct-access or left/right key?
The USR-5 has two kinds of key definitions: global and per-device. Whenever there is no per-device definition
(or an empty per-device definition), the global definition is used. There is only one global definition per key, but
there is a per-device definition per key for every device and macro group.
•
to assign an IR code to the global definition of a key:
1. Double-click on
System Properties
underneath
HOME
in the
configuration tree view.
2. The USR-5 System Properties sheet appears. Select the
Hard Keys
tab, click on the key as shown left, which you want to assign an IR
code, and proceed with step 4 of
How do I assign an IR code to a
button?
.
•
to assign an IR code to the per-device definition of a key:
1. Double-click on the
Properties
item underneath the device or macro group
in the configuration tree view for which you want to assign an IR code.
2. The Device Properties or Macro Group Properties sheet appears. Select
the
Hard Keys
tab, click on the key as shown left, which you want to
assign an IR code, and proceed with step 4 of
How do I assign an IR
code to a button?
.
How do I assign a source switch IR code?
1. Double-click on the
Properties
item underneath the device or macro group
in the configuration tree view for which you want to assign a source switch
IR code.
2. The Device Properties or Macro Group Properties sheet appears. Select
the
Action
tab and proceed with step 4 of
How do I assign an IR code to
a button?
.
Summary of Contents for CHAD
Page 1: ...ChadEdit User Guide...
Page 10: ...ChadEdit User Guide 10...