![background image](http://html.mh-extra.com/html/onkyo/29400021/29400021_instruction-manual_1637357107.webp)
107
NET
The AV receiver is
network-ready,
which means you can
hook it up to your home network with a standard Ether-
net cable and enjoy the music files stored on your com-
puter or media server. If your network is connected to the
Internet, you can also enjoy Internet radio.
Network Requirements
■
Ethernet Network
The AV receiver’s Ethernet port supports 10Base-T. For
best results, a 100Base-TX switched Ethernet network is
recommended. Although it’s possible to play music on a
computer that’s connected to the network wirelessly,
playback may be unreliable, so wired connections are
recommended.
■
Ethernet Router
A router manages the network, routing data and supply-
ing IP addresses. Your router must support the following:
• NAT (Network Address Translation). NAT allows sev-
eral networked computers to access the Internet simul-
taneously via a single Internet connection. The
AV receiver needs Internet access for Internet radio.
• DHCP (Dynamic Host Configuration Protocol).
DHCP supplies IP addresses to network devices,
allowing them to configure themselves automatically.
• A router with a 100Base-TX switch built-in is recom-
mended.
Some routers have a modem built-in, and some ISPs
require you to use specific routers. Please consult your
ISP or computer dealer if you’re unsure.
■
CAT5 Ethernet cable
Use a shielded CAT5 Ethernet cable (straight-type) to
connect the AV receiver to your home network.
■
Internet Access (for Internet radio)
To receive Internet radio, your Ethernet network must
have Internet access. A narrowband Internet connection
(e.g., 56K modem, ISDN) will not provide satisfactory
results, so a broadband connection is strongly recom-
mended (e.g., cable modem, xDSL modem, etc). Please
consult your ISP or computer dealer if you’re unsure.
Notes:
• To receive Internet radio with the AV receiver, your
broadband Internet connection must be working and
able to access the Web. Consult your ISP if you have
any problems with your Internet connection.
• The AV receiver uses DHCP to configure its network
settings automatically. If you want to configure these
settings manually, see page 113.
• The AV receiver does not support PPPoE settings, so
if you have a PPPoE-type Internet connection, you
must use a PPPoE-compatible router.
• Depending on your ISP, you may need to specify a
proxy server to use Internet radio. If your computer is
configured to use a proxy server, use the same settings
for the AV receiver (see page 113).
To connect the AV receiver to your home network, plug
one end of a shielded CAT5 Ethernet cable into the
AV receiver’s ETHERNET port, and plug the other end
into a LAN port on your router or switch.
The following diagram shows how you can connect the
AV receiver to your home network. In this example, it’s
connected to a LAN port on a router, which has a 4-port
100Base-TX switch built-in.
About NET
Connecting the AV Receiver
ETHERNET
Internet radio
Modem
Router
Computer or media server
LAN/Ethernet port
WAN port
LAN port
LAN port
TX-NR807_En.book Page 107 Tuesday, July 28, 2009 12:00 PM
Summary of Contents for 29400021
Page 147: ...147 Memo ...