11451 Belcher Road South, Largo FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • [email protected]
F-1500 Turbine Flow Meter Manual 02/18 - 1018-6 / 35726
Page 33
SECTION 3: OPERATING INSTRUCTIONS
After installing the flow meter, you are ready to begin operation. The sections in this chapter explain
the display / keypad commands, meter start-up and programming. The meter is ready to operate at
start-up without any special programming. To enter parameters and system settings unique to your
operation, see the following pages for instructions on using the set-up menus.
3.1 FLOW METER DISPLAY/KEYPAD
The flow meter’s digital electronics allow you to set, adjust
and monitor system parameters and performance. A full range
of commands are available through the display/keypad. The
LCD display gives 2 x 16 characters for flow monitoring and
programming. The six push-buttons can be operated with the
enclosure cover removed. Or, the explosion proof cover can
remain in place and the keypad operated with a hand-held
magnet positioned at the side of the enclosure as shown in the
illustration at the left.
Figure 39. Flow Meter Display / Keypad
From the Run Mode, the
ENTER
key allows access
to the Set-up Menus (through a password screen).
Within the Set-up Menus (through a password
screen). Within the Set-up Menus, pressing
ENTER
activates the current field. To set new parameters,
press the
ENTER
key until an underline cursor
appears. Use the
⇑
⇓
⇐
⇒
keys to select new
parameters. Press
ENTER
to continue. (If change
is not allowed,
ENTER
has no effect.) All outputs
are disabled when using the Set-up Menus.
The
EXIT
key is active within the Set-up Menus.
When using a Set-up Menu,
EXIT
returns you to
the Run Mode. If you are changing a parameter
and make a mistake,
EXIT
allows you to start over.
The
⇑
⇓
⇐
⇒
keys advance through each screen
of the current menu. When changing a system
parameter, all
⇑
⇓
⇐
⇒
keys are available to enter
new parameters.
F-1500 SERIES