Once AgriShift LCL-0.2-120V, Installation And User Manual

Page: 26 / 40

AgriShift
®
Lighting Control Unit MASTER - Model LCL-0.2
24
SEC
TIO
N 5
Select the output you wish to setup and press
.
Define the lighting output settings as fol-
lows:
1. Check
Enable to enable the output.
2. To associate an external dimmer to the light output, make sure that the
dimmer was previously connected to the controller (refer to the wiring
diagram in annex D-2) and then select the corresponding Dimmer . If
the lighting output does not have a dimmer, indicate ---.
5.1 CONFIGURATION - OUTPUTS
This menu allows activating the variable
outputs of the AgriShift
®
lighting control-
ler
.
5 CONFIGURATION
The Configuration menu allows the user to
configure all settings of the AgriShift
®
ligh-
ting system.
From the Configuration menu, select the
desired submenu among the following and press
.
Configuration
Outputs
Advanced Parameters
Local Settings
System Version
EXTERNAL DIMMER FUNCTIONING
If the dimmer is fully turned to the
left (AUTO), the lighting outputs
associated with this dimmer are in
automatic mode and vary in inten-
sity depending on the lighting
program setup in the AgriShift
®
lighting system. When turning the
dimmer clockwise, the lighting
outputs switch from automatic to
manual intensity (between 0 and 100%, depending on the position of the
dimmer). It is important to note that the intensity selected in manual mode
will be preserved indefinitely as long as the dimmer is not set into the AUTO
position. If a potentiometer failed, disable it (in the configuration of the
lighting output) during its replacement to preserve the automatic mode).
Output A
Enable
b
Dimmer
Calibration Dimmer 1
Edit
Output A
Output B
Outputs
External Dimmer Adjustment Knob