Once AgriShift LCL-0.2-120V, Installation And User Manual

Page: 28 / 40

AgriShift
®
Lighting Control Unit MASTER - Model LCL-0.2
26
SEC
TIO
N 5
5.2 CONFIGURATION - ADVANCED PARAMETERS
The Advanced settings menu allows the user to configure advanced settings
for additional operating parameters related to power expansion bus and
lighting control.
As the controller starts, parameters are initialized to default values (shown
below), thereby allowing the standard utilization of the AgriShift
®
system.
The user can decide whether to customize these values to meet the specific
needs of the production environment.
- If this value is lower than desired for a 25% power , enter a
larger value.
- If this value is greater than that desired for a 25% power , enter
a smaller value.
Repeat as needed until the desired value is achieved.
3.4 Repeat step 3.3 for the following intensities ( Intensity50%, Intensity
75%, and Intensity 100% ). At any time, the output can be disabled by
selecting Stop
.
MASTER mode
SLAVE mode
Advanced Parameters
--Power Expansion--
Master Mode
Output A Master Output
--Lighting Control--
Independ Curve
Advanced Parameters
--Power Expansion--
Slave Mode
Mode : This option allows selecting the operating mode (master or slave)
of the controller. Master mode indicates to the controller to apply the
lighting program (depending on the period and lighting cycle defined for
the production day and system time). The master controller also applies a
low intensity signal (between 0 and 10 volts) to the power expansion bus,
which is proportional to the current intensity required by the lighting
setpoint. This signal is interpreted by all slave controllers to modulate their
outputs connected to an intensity requested by the master controller.
Set switch SW4 to the master position while the controller is
in Master mode. Otherwise, set the switch to Slave mode
.
5.2.1 Power Expansion (Master/Slave Mode)