Omron XW2B Series, Connection Manual

Page: 12 / 12

WX2B WX2B
12
For W-Series Servo Driver and Servo Terminal Block
XW2Z-
jjj
J-B4
Wiring Diagram
XW2Z-
jjj
J-B4
Connector
Servo Driver side
R88D-WT
j
Position Control
Terminal Block side
Position Control Terminal Block
Symbol
Cable: AWG28
×
4P + AWG28
×
9C
Servo Drive
XW2B-20J6-1B
XW2B-40J6-2B
L
t=18
30
39
52.4
6
Precautions
J
WIRING
The open terminal must be left unconnected.
0 V and common terminals are connected internally.
Do not wire the Servo Screw Terminal Block while power is
supplied to the unit, or the terminals may be short-circuited with
the cable and the Unit may malfunction.
J
TERMINAL WIRE CONNECTIONS
The suitable crimp terminal is R1.25--3 (round or fork type).
Terminal Screw Tightening Torque
When connecting crimp terminals or wires to the terminal block,
be sure to tighten each crimp terminal or wire to 0.5 to 0.8 N
•
m
(4.9 to 7.8 kgf
•
cm).
J
TRACK MOUNTING
More than one XW2B Position Control Screw Terminal Block can
be densely mounted to a DIN track, in which case, move the
mounting stays from both sides of the XW2B to the bottom of the
XW2B.
Secure both ends of the XW2B with end plates.
Cat. No. P20BFAD2 08/01 Specifications subject to change without notice. Printed in U.S.A.
OMRON ELECTRONICS LLC
One East Commerce Drive
Schaumburg, IL 60173
NOTE: DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters to inches divide by 25.4.
1-800-55-OMRON
OMRON CANADA, INC.
885 Milner Avenue
Scarborough, Ontario M1B 5V8
416-286-6465
R
OMRON ON--LINE
Global -- http://www.omron.com
USA -- http://www.omron.com/oei
Canada -- http://www.omron.com/oci