Omron V720S-BC5D4A, User Manual

Page: 87 / 149

5-3
Command-Response Format 5-3
5-26
5-3-7-2 I.CODE1 Mode
Type
Response
Code
Name Description
“00” Normal completion The received command ends normally with no error.
Multi-processing end
Communications end response when a multi-trigger function is used.
“72”
Selective detection completion Communications end response when a selective access/detection
function is used.
“74” Polling command received
･
Polling command has been received normally.
･
Polling Check is received before the completion of communications
with a Tag.
Polling processing canceled Polling processing is canceled before the completion of
communications with a Tag. “75”
Data normal Results of the memory calculation command (MK) check code
verification are normal.
Polling processing canceled Polling processing is canceled after the start of communications with
a Tag.
Normal
completion
“76”
Data error Results of the memory calculation command (MK) check code
verification show an error.
“10” Parity error A parity error occurs in one of the characters of the received
command.
“11” Framing error A framing error occurs in one of the characters of the received
command.
“12” Overrun error An overrun error occurs in one of the characters of the received
command.
“13” BCC error The received command has an incorrect BCC.
“14” Format error
･ The command format is incorrect.
･
A stop command is received in command-waiting status.
In Selective Access mode;
1) A temporary number not saved using the Tag detection
command is specified.
2) A tag detection command normal end is retried after it has
been sent.
･
The specified, Temporary number is not saved by Tag
Detection Command.
･
An ISO-mode specific command/function is executed.
Host
communications
error
“18” Frame length error
・
ETX is not received in 289 characters or less after STX is received.
“70” Communications error ･ An error occurs during the communications with a Tag, and
communications cannot end normally.
“71” Write process error ･ Tag is in an area that can be read, but not written to.
･ You are trying to write to a locked page (i.e., write-protected).
･
The correct data cannot be written to the Tag.
･
Verify read results in an error.
Communication
s error
“72” No Tag error ･ No Tag is present in front of Antenna when a Trigger command is
executed.
･
There are multiple Tags within the communications area when
using Single Access mode.
“7C” Communication circuit error
・
An error occurred in the Reader/Writer communication
circuit.
System error
“93” Memory error
・
The EEPROM for the operating condition setting cannot be
re-written normally.
“01” Specified No. of Tags exceeded
・
More Tags than have been specified in the Tag No. setting have
entered the communications area.
“02” Specified No. of retries exceeded ・ Tag detection has been retried the specified number of times to
find all the Tags in the communications area, but some Tags have
not been detected.
“03” No. of Tags exceeded
No. of retries exceeded ・ Two of the warning, “01” and “02,” have occurred.
“04” Communications error ・ An error occurs during communicating with Tags, resulting in
successful communications with only some of the Tags.
“05” Specified No. of Tags exceeded
Communications error ・ Two of the warnings, “01” and “04,” have occurred.
“06” No. of Tags exceeded
Communications error
・
Two of the warnings, “02” and “04,” have occurred.
Warning
“07” No. of Tags exceeded
No. of retries exceeded
Communications error ・ All the three warnings, “01,” “02,” and “04,” have occurred.
：
The warning code is issued for Multiple Trigger(MT) and Multiple Repeat(MR) Modes only.