Omron V720S-BC5D4A, User Manual

Page: 122 / 149

5-7
Setting Command 5-7
5-61
5-7-13 Set Value Initialization (IS)
If necessary, you can return all the settings to their factory settings.
<Command Format>
STX Node No. Command
code
"IS"
ETX BCC
1 2 2 1 1
<Response Format>
STX Node No. Retry
flag
Command
code
"IS"
Response
code:
"00"
ETX BCC
1 2 1 2 2 1 1
Response code: 00: Normal completion
For other Response Codes, refer to SECTION 5-3-7 Response Code List.
・
The factory defaults vary, depending on the software version. The difference must be taken into
account when executing the command.
・
The factory defaults vary, depending on the software version. The difference must be taken into
account when executing the command.
5-7-14 Set Value Writing (EW)
This command is executed to keep the settings made by the commands after recovering the
power of the Reader/Writer.
<Command Format>
STX Node No. Command
code
"EW"
ETX BCC
1 2 2 1 1
<Response Format>
STX Node No. Retry
flag
Command
code
"EW"
Response
code:
"00"
ETX BCC
1 2 1 2 2 1 1
Response code: 00: Normal completion
For other Response Codes, refer to SECTION 5-3-7 Response Code List.
： ・
On successful completion of this command, the settings are written to the
nonvolatile memory (EEPROM) of the Reader/Writer. Once the EW command has been
executed, all the settings made up to this point in time are written to the nonvolatile memory,
thereby eliminating the need to execute this command every time you make a setting.
・
If Set Value Writing (EW) is not executed, the value specified will be reset to original value at
the next start-up.