3-1 Controller
3-14
♦
Assembling and connecting a connector for communication
Use our connector for communication, which comes with the controller. Prepare a connecting cable and connector for a host computer
by yourself. Our connector which comes with the controller is based on the countermeasures against EMI.
(Instead of our connector which comes with the controller, you may use any other commercial connector. Refer to "Appendix 2 Order
Format List".)
* 1. One set of connectors (based on the countermeasures against EMI) comes with the ID controller.
* 2. You may use any other cable if the cable specifications are the same as ours. (The outer diameter is 7 mm.)
♦
How to assemble a connector
(1)Terminate the cable properly.
(2) Solder the core and plug pin.
To the ID controller
Plug
Model XM2A-0901
(which comes with the
controller)
(OMRON)
Hood
Model XM2S-0911 *1
(which comes with the controller)
(OMRON)
•
Recommendable cable
CO-MA-VV-SB 5PX28AWG *2
(Hitachi Cable)
Connecting cable
To the host computer
Core
Shield braid
Shield tape
Cable bush
(Unit: mm)
• Fit the cable bush in the cable in advance.
• Ravel the shield braid, turn back it and cover the
cable bush with the shield braid. The length of the
shield braid covering the cable bush should be 10
mm.
• Wind the shield tape on the shield braid.
Plug
Crossover
Aluminum tape
Cable bush
Note: Short-circuit No. 7 (RS) and No. 8 (CS) pins with cross-
over.
Pin No.
Code
Name
Shield
GR
Ground
5
SG
Ground for signal
3
SD
Send data
2
RD
Receive data
7 (Note)
RS
Request to send
8 (Note)
CS
Clear to send
Summary of Contents for V670-H11
