Attachment
NV3Q-ATT02
INSTRUCTION SHEET
Thank you for purchasing this OMRON product.
Please check that the product is the one that you ordered
and read through this instruction sheet thoroughly before
using the product. Refer to the manual for the NV-series PT for
detailed specifications and mounting procedures.
Please retain this sheet for future reference.
OMRON Corporation
© OMRON Corporation 2009 All Rights Reserved. 1177594-7A
The NV3Q-ATT02 Attachments are special NV3Q attachments
that enable mounting an NV3Q-series Programmable Terminal
(PT) to a control panel cutout to which an NP3 PT was
previously mounted without modifying the control panel.
Precautions for Safe Use
(1) This product is designed to convert the mounting dimensions
of an NP3 to enable an NV3Q-series PT to be mounted to the
same control panel cutout. This Attachment is neither water
nor dust resistant. Do not use this Attachment in
environments requiring water or dust resistance.
(2) The mounting panel must be between 1.6 and 3.0 mm thick.
Package Contents
Check the contents of the package before using the Attachment
to see if anything is missing.
NV3Q-ATT02 Attachment, 1 set
PLATE (1): 1, PLATE (2): 1
Instruction Sheet (this sheet), 1
Applicable PT Models
The NV3Q-ATT02 Attachments can be used for the PTs listed in
the following table. Use the correct Attachment for the PT.
Attachment Applicable
PTs
NV3Q-ATT02 NV3Q-MR
@@
, NV3Q-SW
@@
Note: NP3-series PT panel cutout dimensions are 118.5
×
92.5 mm
(horizontal
×
vertical).
Specifications
Attachment Dimensions
z
PLATE (1)
z
PLATE (2)
Attachment Mounting Dimensions
Panel cutout (118.5
×
92.5 mm (H
×
V))
Precautions for
Correct Use
Do not place parts or anything else on the
shaded area.
Attachment Mounting Method
1. As shown in the following figure, insert PLATE (1) and then
the NV3Q from the front of the control panel.
PLATE (1)
NV3Q
2. Insert PLATE (2) onto the NV3Q and PLATE (1) from the
back of the control panel.
PLATE (2)