Omron NT-series, Operation Manual

Page: 80 / 318

- .
Section 3-1
4-1 Operation Flow by the System Menu
Follow the procedure below when using the NT600S for the first time or when
changing the system.
Create the Screen Data
Create the screen data to be displayed on the NT600S by using a
support tool.
For the screen data creation, refer to the “NT-series Support Tool
Operation Manual” (V028-E1-
).
Although the screen data can be created with the previously avail-
able support tool, there are several restrictions if such a tool is used.
For details, refer to Appendix G Function Restrictions Depending
on the Support Tool (page 277).
Start Up the NT600S (Display the System Menu.) (page 67)
Turn ON the power to the NT600S.
When no screen data has been registered, the “SYSTEM MENU”
will be displayed. If the NT600S enters the RUN mode, press ap-
propriate touch switches to display the System Menu.
Initialize Memory (page 72)
Select a System Menu and initialize the NT600S unit memory.
Transfer the Screen Data (page 79)
Connect a support tool to the NT600S and transfer the screen data
from the support tool to the NT600S.
For the connection of a support tool, refer to Section 2-3 Connecting
to the Support Tool. (page 30)
Memory Switch Setting (page 83)
Select the System Menu and set the conditions for communications
with the PC/Host using the memory switch.
Start the Operation (page 92)
Connect to the PC/Host and start the operation.
System Maintenance (page 101)
If an error has occurred during operation, check the I/Os, settings,
etc. referring to this guide.