Omron NSA12-15-TX11B, User Manual

Page: 13 / 114

xiii
Caution
Hold the connector housing when disconnecting the power connection cable.
Hold the connector housing, rather than the cable, when disconnecting the cable.
Pulling the cable may break wires inside, which may result in heating or fire.
Observe all relevant standards and environmental conditions.
Observe all standards for power supply voltage, frequency, capacity, etc. Using the
product under conditions not prescribed by these standards may cause electric shock
or fire.
Do not place objects on top of the product.
Do not place objects on top of the product or press on the product. Doing so may
damage the product and result in injury.
Do not place objects near the ventilation holes.
Do not place objects near the ventilation holes, or block the holes in any way. Doing so
may cause the product to malfunction.
Do not tip the product over or strike it with anything.
Do not subject the product to vibration or impacts, particularly when the power is ON. If
the product is subjected to impacts by being dropped or struck, it may fail to operate
correctly.
Do not use or store the product in the following locations.
Using or storing the product in any of the following locations may cause electric shock,
fire, or malfunction.
•
Locations that are unstable or subject to vibration
•
Locations subject to static electricity
•
Locations subject to dust or high humidity
•
Locations subject to direct sunlight
•
Locations subject to flames or heat accumulation
•
Locations subject to exposure to chemicals
•
Locations close to heating or cooling equipment
•
Locations subject to water seepage
•
Locations subject to ground faults
Do not use the product near a radio, television, or cordless telephone. Doing so may
cause electrical noise to enter the product or the radio, television, or cordless
telephone, preventing correct operation.
Do not allow condensation to form on or in the product.
Installing the product in a location with high humidity, or installing the product indoors
soon after bringing it in from the outdoor cold may cause condensation to form on or in
the product, and using the product in this condition may cause malfunction.
Dispose of the product and batteries correctly.
The product contains lithium batteries. Dispose of the product and batteries according
to local ordinances as they apply. Have qualified specialists properly dispose of used
batteries as industrial waste.
Provide sufficient working space.
Prior to moving the product or replacing components, ensure that there is sufficient
room and no interfering obstacles.