OMRON
NS Series Quick Start Manual
Page 9
2.3 NS5 Rear Panel
Local Bus Interface Connector
Used to connect to an Expansion Interface Unit.
(It cannot be used with NS Ver. 5.0 systems.)
Current
Expansion Interface Units cannot be connected.
Reset Switch
Used to initialize the PT. The status
of
screen
data, other registered data,
and memory switches, however, will
not change.
Serial Port A Connector
Used to connect
the host, NS
-
Designer,
and Bar Code Reader.
Uses a
n
RS
-
232C 9-
pin connector.
Battery Cover
The battery is installed
underneath the cover.
DIP Switch
Used to set the settings for
transmitting data using the
Memory Card.
Memory Card Connector
Used to connect the memory card for
storing and transmitting screen data, log
data, and system programs.
Serial Port B Connector
Used to connect the host, NS -Designer,
and Bar Code Reader. Uses a n RS-232C 9-
pin connector.
Power Supply Input Terminals
Used to connect
the power supply.
Ethernet Connector
Used to connect the Ethernet cable.
Uses a 10Base
-T/100Base -T 8-pin
m
odular plug.
USB Slave Connector
This is a USB Type B connector.
(It cannot be used with NS Ver. 5.0
sy
s
tems.)
FG Terminal
Used to prevent malfunctions
due to noise interference.
2.4 Starting the PT for the First Time
Always perform the following operations when turning ON the PT for the first time
after purchase.
A. Select the operating language.
B. Format the screen data area.
C. Set the date and time.
Operate according to the following conditions.
1. When the power is turned ON to the PT, the error message will be displayed.
Press the OK Button.
2. The System Menu will be displayed. Almost all texts are Japanese. You should see
the language selection box on the lower right (Select Language). Select English
and press the [Write] button. The question window will appear. Press the left
button, which means YES (text is Japanese). The completed message will
appear so press [OK] button. Now all texts should be in English. See the picture
below:
