20
Connecting to Ethernet (EtherNet/IP)
Section 2-4
5.
For the
Target IP Address
, specify the present IP address of the ED Router
for which the IP address is to be set.
6.
To change the IP address, select
Use the following IP address
and then set
the new IP address.
7.
Click the
Set to the Device
Button.
The ED Router will restart automatically.
8.
Check the 7-segment display on the ED Router.
If the 7-segment display is tested again after it goes OFF, and finally dis-
plays the DeviceNet node address, it indicates that the ED Router has rec-
ognized the new TCP/IP Configuration settings.
Note
(1) The ED Router will restart automatically when the TCP/IP Configuration's
IP address parameters are downloaded to the ED Router from the Net-
work Configurator. The ED Router must restart to enable the parameter
settings. Download the TCP/IP Configuration's IP address parameters
only after verifying that restarting the Unit will not cause any problems in
the system.
(2) The IP address can be checked on the 7-segment display by pressing the
ED Router service switch for 1 s or longer and then releasing it.
(3) With an ED Router parameter setting, the value normally displayed on the
7-segment display can be changed to the rightmost byte of the IP ad-
dress.
Summary of Contents for NE1A-EDR01
