Omron MicroHAWK F320-F, User Manual

Page: 138 / 146

D-7
Appendices
MicroHAWK F320-F / F330-F / F420-F / F430-F Smart Camera User Manual
D
Sets value of a global tag.
The tagname must correspond to one of the supported tags within the device. Use the INFO command
to get a full list of tags and services, as well as attributes of the tag and list of subtags.
The value can contain spaces.
The command is terminated by a carriage return and/or line feed character.
The value can be a list of comma-separated items to set a sequence of tags:
Send SET int1 1, 2, 3 to set int1 = 1, int2 = 2, int3 = 3.
The AVP service allows setting of step and datum information from the job tree using forward slash ‘/’ in
the symbolic name path.
SET avp/insp1/snapshot1/acq1/gain 2.0 paths are not case-sensitive and
do not need to be fully qualified if unique.
SET avp/acq1/gain 2.0 will set the same gain value if there is only one acquire.
Control tags in the AVP service such as START , STOP , and TRIGGER act as momentary switches.
SET avp.start 1 is equivalent to the ONLINE command. avp.start will reset immediately and always
read as 0 .
Success Return: On success will return !OK followed by an echo of the command.
For example:
!OK SET matchstring1
Fail Return: On failure will return !ERROR followed by the reason for the failure.
For example:
!ERROR Tag matchstring66 not found
Sets units used for autofocus, mm (0) or inches (1) .
Important: The MicroHAWK F430-F only supports mm so SETFOCUSUNITS will only accept 0 and
anything else will respond with !ERROR .
Turns targeting LEDs On or Off.
target 1 = Turn Target On
target 0 = Turn Target Off
Triggers an inspection.
Returns Visionscape software version.
SET <tagname> <value>
SETFOCUSUNITS
TARGET {0|1|off|on}
TRIGGER
VERSION