6
24-hour/Weekly Time Switch
H2F
Precautions
Flush Mounting
1. To mount the adapter to the panel cutout, first deform the adapter
by pushing it on the two opposing corners (as indicated by arrows
A. Then push part B into the cutout (i.e., toward the back of the
panel).
2. After the adapter is mounted, insert the H2F as shown in the fig-
ure below. Secure the H2F by tightening the two mounting screws
(M3 x 16) included as accessories.
3. If the lead wires have been connected to the H2F from the front of
the panel before the H2F is mounted in the panel, engage the
H2F to part A of the adapter and push it in the direction of B. Then
tighten the two screws as described in 2.
Time Setting
To set the time, turn the center knob clockwise to the correct time.
Turning it counterclockwise or turning it with your fingers hooked on
the setting bracket may cause a malfunction.
With 24-hour models, set the hour to the arrow on the upper left cor-
ner of the front panel and the minute to the arrow on the center knob.
With 1-week models, set the day of the week to the arrow on the
upper left corner of the front panel and the hour to the arrow on the
center knob.
Use the gold setting tabs to set the ON time and the silver ones to set
the OFF time. Position the thick leg of the tab toward the outside of
the dial and insert the tab securely into the groove on the dial.
Three pairs of setting tabs are attached.
Store the spare tabs in the compartment at the lower right corner of
the front panel.
Panel
Adapter
B
A
Panel
Lead wire
B
A
H2F Time Switch