![background image](http://html1.mh-extra.com/html/omron/e5ax-ba-series/e5ax-ba-series_manual_744336020.webp)
E5AX-BA/BAH/E5EX-BA/A02/A03
E5AX-BA/BAH/E5EX-BA/A02/A03
20
Connection Examples
With Solderless Terminal
Use M3.5 solderless terminals with the Temperature Controller’s
M3.5 self-rising pressure plate screws.
Solder-dipped Leads
Strip 6 to 12 mm of the lead wires and carefully arrange the wire tips.
Do not tighten the terminal screw with excessive force, because do-
ing so may damage them. The terminal block of the Temperature
Controller is constructed so that the lead wires can be connected to
all the terminals from the same direction.
Top
Bottom
Input Type Connection
To reduce inductive noise influence, the lead wires connecting the
input type to the Temperature Controller must be separated from the
power lines and load lines.
Use the specified compensating conductors for thermocouples.
Use lead wires having a small resistance for platinum resistance
thermometers.
Sequenced Circuits
Several seconds are required until the relay is turned ON after pow-
er has been supplied to the Temperature Controller. Therefore, take
this time delay into consideration when designing sequenced cir-
cuits which incorporate a Temperature Controller.
Terminal Arrangement Diagram on the Housing
The Temperature Controller allows the input and output devices to
be freely selected. Use the terminal arrangement diagram shown on
the housing of the Temperature Controller to identify the output de-
vice mounted on the Temperature Controller by marking the dia-
gram as follows:
Check here with a felt-tip pen.
Stickers Inside Frontcover
Stickers indicating the input type (R, S, K, J, etc.) and Control Output
Unit (R, S, Q, and C) are supplied with the Temperature Controller.
Attach the proper stickers to the front panel as shown below, allow-
ing the input type and Control Output Unit mounted in the Tempera-
ture Controller to be easily identified.
Sticker identifying input type
Sticker identifying Control Output Unit
(The above is the E5EX-BA.)
OMRON Corporation
Temperature Control Devices Division
29th Fl., Crystal Tower Bldg.
1–2–27, Shiromi, Chuo-ku,
Osaka 540 Japan
Phone: 06-949-6070
Fax: 06-949-6084
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.
Cat. No. H38–E1–3
In the interest of product improvement, specifications are subject to change without notice.
Printed in Japan
0492–3M (0492)