![background image](http://html1.mh-extra.com/html/omron/3g8b3-srm00/3g8b3-srm00_product-manual_742321034.webp)
SRT2-VID/VOD
SRT2-VID/VOD
43
Specifications
Ratings
Inputs
Item
SRT2-VID08S
SRT2-VID08S-1
SRT2-VID16ML
SRT2-VID16ML-1
Input current
6 mA max./point at 24 V, 3 mA max./point at 17 V
ON delay time
1.5 ms max.
OFF delay time
1.5 ms max.
ON voltage
15 VDC min. (Between each input terminal and V: NPN. Between each input and G: PNP.)
OFF voltage
5 VDC max. (Between each input terminal and V: NPN. Between each input and G: PNP.)
OFF current
1 mA max.
Insulation method
Photocoupler
Maximum number of inputs
8
12
Number of circuits
8 points/common, 1 circuit
16 points/common, 1 circuit
Outputs
Item
SRT2-VID08S
SRT2-VID08S-1
SRT2-VID16ML
SRT2-VID16ML-1
Rated output current
0.3 A/point
0.3 A/point (2-A common) (See note.)
Residual voltage
1.2 V max.
ON delay time
0.5 ms max.
OFF delay time
1.5 ms max.
Leakage current
0.1 mA max.
Insulation method
Photocoupler
Number of circuits
8 points/common, 1 circuit
16 points/common, 1 circuit
Note:
When using V/G terminals in an MIL connector, ensure that the current per terminal for the V/G terminals does not exceed 1 A.
Characteristics
Communications power supply
voltage
14 to 26.4 VDC
I/O power supply voltage
20.4 to 26.4 VDC (24 VDC
+10%
/
–15%
)
I/O power supply current
Sensor connector: 2.4 A max., MIL connector: 2.0 A max.
Current consumption (see note)
50 mA max. at 24 VDC
Noise immunity
Conforms to IEC61000-4-4, 2 kV (power lines)
Vibration resistance
10 to 150 Hz, 1.0-mm double amplitude or 70 m/s
2
(50 m/s
2
for SRT2-ATT02)
Shock resistance
200 m/s
2
Dielectric strength
500 VAC (between insulated circuits)
Ambient temperature
Operating:
–10
°
C to 55
°
C (with no icing or condensation)
Storage:
–25
°
C to 65
°
C
Ambient humidity
Operating:
25% to 85% (with no condensation)
Storage:
25% to 85%
Mounting strength
No damage when 100 N pull load was applied in all directions (40 N load for SRT2-ATT02)
Terminal strength
No damage when the following loads were applied:
Communications connector: 100 N
Sensor connector: 40 N
MIL connector: 100 N
Screw tightening torque
Communications connector: 0.25 N
S
m
Node address setting
Settings made at DIP switch (set before supplying power for Slave communications)
Weight
Approx. 75 g max.
Note:
The above current consumption is the value with all points turned ON excluding the current consumption of the external sensor con-
nected to the input Remote Terminal and the current consumption of the load connected to the output Remote Terminal.