21
5
INSTALLATION
Placing the Receiver
For best transmission quality place the transmitter at the height of the receiver and avoid obstacles between
the transmitter and the receiver, e.g. metal, dense materials, computers or other RF generating equipment
(at least 50 cm distance). The transmitter also should have a distance of approx. 1 m from lateral walls. For
483 mm rack installation (19"), screw on the two mounting brackets at the left and right sides of the housing.
Please make sure that there is enough space around the unit so that the heated air can be passed on.
Steady overheating will damage your device.
Connecting the Transmitter
1
Connect the signal source(s) with line level (e.g. stereo output or monitor outputs of a mixing console)
via balanced XLR or 6.3 mm plugs to the inputs
LEFT INPUT
and
RIGHT INPUT
. If only an unbalanced
signal is available, it may be connected to the input jacks by means of 6.3 mm mono plugs.
Note: In mono mode, only the input signal of the right channel will be sent.
2
To monitor the audio signal directly on the transmitter stereo headphones can be connected to the
6.3 mm jack
HEADPHONES
.
3
Insert the supplied antenna into the rear BNC jack
ANTENNA
. Set up the antenna in a vertical position.
4
Finally, connect the power supply unit to the power input of the transmitter and the mains plug to a
mains socket. Use the transmitter only with the supplied power unit. Always disconnect the mains
connector when you wish to change connections, move the unit to a different place or if it is not used for
a longer period.
Inserting Batteries into the Receiver
For operation, the receiver requires two 1.5 V mignon batteries. Unfold the
front cover and insert the batteries as indicated in the battery compartment.
The capacity of the batteries is indicated on the display:
With new batteries, the receiver can be operated for approx. 7 hours. If the
battery indicator starts flashing red, the batteries are going flat and the
receiver switches off automatically within a short time.
If the receiver is not used for a longer period (approx. 1-2 weeks), please
remove the batteries to prevent damage in case of battery leakage. Please
refer to further explanations in chapter Safety Instructions.
Fastening the Receiver and Connecting the Earphones
Attach the receiver via the belt clip to your belt or strap on your
instrument. When using a wireless microphone or a transmitter for a
musical instrument at the same time, do not place the devices side
by side but place them apart in order to avoid interference. It will
sufficient to place one device on the right side and one on the left
side of your body.
Connect the supplied earphones to the 3.5 mm jack on the receiver.
For optimum fit of the earphones, delivery includes three pairs of
silicone sleeves of different sizes. Insert the earphones for the left
ear marked L and for the right ear marked R into your ears and lead
the cable over your outer ear to the back of your head. This will
ensure a tighter fit than leading the cable directly downwards.
