OmniSTAR 5220HP, User Manual

Page: 47 / 83

OmniSTAR 5220HP User Manual
Issue 1.32 12/2010
47
OmniSTAR commands
This section details the commands accepted by the OmniSTAR 5220HP
receiver to configure and monitor the OmniSTAR functionality of the receiver.
For each command the following table provides a brief description, which will
be detailed in a further subsection.
$JFREQ This message allows you to either manually
or automatically tune the OmniSTAR receiver
$JLBEAM This message displays information on the
spotbeams available to OmniSTAR receivers
$JLBEAMEX This message displays extensive information
on the spotbeams that are broadcasted over
the OmniSTAR network and are used to
enable automatic satellite selection
$GEO This message displays information about the
position, azimuth and elevation of the
OmniSTAR satellite currently in use by your
receiver
$JOMS This command requests the current
OmniSTAR subscription information
$JLIMIT This command changes the threshold of
estimated horizontal DGPS performance for
which the green LED is illuminated
$JASC,D1 This command is used to request diagnostic
information from the OmniSTAR receiver
module
$JOMD This command allows you to configure the
receiver to output Debug data
$JHP,POS This command sets or displays the current
position
$JHP,SEED This command allows you to seed a current
position in order to reduce HP initialization
time
Table 3: OmniSTAR commands