10
3.3 Mounting the Camera Turret
The Camera Turret holds the imaging module, optics and Pan/Tilt platform. The Camera Turret
can be configured to be installed ball-up (upright) or ball-down (upside-down) position. Identify
and select a position with a clear line of sight to the intended observation area. The mounting
area should also be secure and free from excessive vibration.
1. Take note of the orientation of the Camera Turret and place the base forward-facing
relative to the bow of your vessel. There is an arrow mark at the base of the Camera
Turret indicating the forward-facing of the turret for installation. In most cases, this arrow
should point towards the general direction of the bow of the vessel.
2. Using the Mounting Template or Mounting Decal provided, mark and drill the 0.27in (7mm)
holes required for attaching the Camera Turret.
3. Place your Camera Turret base over the screw holes and secure your Camera Turret with
the four M6 studs, washers, spring washers and nuts provided. Note that the thread holes
at the base of the turret have a maximum depth of 0.5in (13mm). We recommend a length
of between 0.3-0.4in (8-10mm) with a thread pitch of 1.0. At no time should the studs
penetrate more than 0.5in (13mm) from the base.
4. Ensure also that you insert the studs correctly and do not cross-thread. Such damages are
not covered under warranty.
5. Take the Camera Harness and run it through the central hole and connect it to the
connector at the base of your Camera Turret.
Ensure depth of screws used do not penetrate more than 0.5in (13mm) from the
base. Failure to observe this may severely damage the product.
