Omnicomm LLS-Ex 5, User Manual

Page: 16 / 33

Omnicomm LLS-Ex 5 Sensor Settings
“Automatic adjustment” - enable to automatically correct the measurements when the
dielectric constant of the fuel changes. The setting is available only after the sensor has
been calibrated.
“Network address” (1 to 254) – set the network address for the Omnicomm LLS fuel level
sensor. When several sensors are connected to one external device, they should have
unique network addresses.
“Min level” (0 to 4095) – select the minimum reading for the Omnicomm LLS-Ex 5 fuel
level sensor. Default value – 0.
“Max level” (1 to 4095) – select the maximum reading for the Omnicomm LLS-Ex 5 fuel
level sensor. Default value – 4095.
“Filtering” – set the output signal filtration parameters:
“No”– no filtration. This option is used when the filtration is carried out by an external
device.
“Minimum”– filtration is used when the device is installed in stationary fuel storages
and non-mobile machinery
“Medium”– filtration is used when the vehicle operates under normal road conditions
“Maximum”– filtration is used when the vehicle operates under harsh road conditions
“Automatic data output” – select:
“Disabled” – no independent data output (without request) is performed
“Enabled” – independent binary data output
“Data output interval” (1 to 255 seconds) – set the automatic data output interval
The automatic data output mode may be used only with maximum one Omnicomm LLS
5 sensor connected to one interface.
“Heavy exploitation conditions” mode - switch on to enable additional filtration of
measurement values taking into account the rough working conditions.
“Parameters initialization” - displays the accuracy of the calibration results. Possible
options:
“Yes” - the calibration results are correct
“No” - sensor recalibration is required
16
Setting