Omnicomm LLS 20230, Installation Manual

Page: 14 / 50

For tanks which shape corresponds with the figure (Figure 2), installation should be
carried out in accordance with Appendix E.
1) Put the gasket included into the product delivery set on the measuring part of the
product (Figure 24).
2) Install the product into the tank.
3) Fix the product to the tank by bolts, having preliminary installed the washer and
the spring washer as shown in the figures (Figure 14, Figure 15). The bolts should be
tightened by a spanner.
4) When the product is installed on plastic tanks with wall thickness over 3mm, the
product must be fixed by a self-tapper included into the delivery set. Self-tapper
tightening strength should be such that the rubber washers put on the self-tapping
screws are not crumpled or burst.
5) When installing the Product with the measuring part length over 1.5 m into fuel
tanks of special vehicles (e.g. petrol tankers, diesel locomotives it is necessary to
14
Installation and Deinstallation