Omnicomm LLS 20230, Installation Manual

Page: 30 / 50

Appendix E. Procedure for Circular Tank Preparation for Product
Installation and Installation Process
Mark the holes for mounting the product taking into account the tank curvature.
Place the bolt into the hole for product mounting so that the bolt is perpendicular to
the surface of the tank (Figure 33).
Drill holes in accordance with the selected type of the tank and method of fixing the
product to the tank.
Apply a thin layer of sealant between the plate of the product body and the rubber
gasket. Put the gasket on the product. Apply hermetic to the prepared tank as shown
in the Figure (Figure 34). The thickness of sealant layer should be at least 5mm.
Perform installation in accordance with selected fixation method (see Section 4).
30
Connection