70
To reset
rameters bac
sy
nel memory card.
e
Saves the
rom
e
hat can be loaded into the processor to run in response to a single relay contact
closure or open. The following scripts do just that—set the Omnia-3fm Turbo to automatically switch to mono
in response t
and to
n when that same contact is
opened.
In scripts, al
syspara” must
that identify the parameter ID
number that is being set and that ID number's new value. The value numbers and their settings for the Pilot
Level were
values and pa
eter, type in
sysparavalues
followed by
eter’s “sysp
(The above “
availabl
Trigger Sc
g to Mo
In this example, we'll configure Trigger Input # 1 to switch the Omnia-3fm Turbo into mono operation when the
contact close
reo when it op
en up the Script Editor and
click radio b
ower edit
gger 1 “Trigger Low” script.
Type:
syspara 54 1 <enter>
This command sets the processor to turn off the 19 kHz pilot tone when it is run. “
syspara 54
” says to edit the
Pilot Level. T
Next, type in:
syspara 2 2
This comma
h the input to “mono left” when run. “
syspara 2
” says to edit the
Mono Mode setting. The “
2
” says select mono left.
of the Trigger LOW Command Script box should look like:
syspara
To set a new value for a Syspara:
syspara
<syspara index #>[<sysparavalue index #>]
all System pa
k to their factory defaults:
sysdefaults
Restores the
stem attributes back to their factory defaults.
To s ve all System settings to the rear-pa
a
syssav
system attributes to the Omnia PC Card.
To load the saved setting f
the rear-panel memory card:
sysload
Loads th system attributes from the currently inserted Omnia PC Card.
Creating a Trigger Script
Now that the scripting commands have been defined, let’s put them to work to create a Trigger Script. We’ll use
one of the most commonly requested operations that FM broadcasters want to easily accomplish: switching
between mono and stereo operation.
This procedure can of course be done by manually using the Omnia-3 front panel controls to turn off the 19 kHz
pilot tone and to switch the input from stereo to mono left. But a far easier method is to use the Trigger Script
Editor to create two scripts t
o a sustained contact closure
then return to stereo operatio
l lines that begin with “
be followed by two numbers
also shown. To list the
rameter settings for any param
a space and then the param
ara” number.
sysparas” table lists all of the
e system parameter numbers.)
ript Example for Switchin
no Operation
s and switch back to ste
ens again. To create this script, op
utton #1. Now click in the l
box to begin entering the Tri
he “
1
” says select Off.
<enter>
nd sets the processor to switc
When you are finished, the contents
syspara 54 1
2 2
