13
DMAN-xxxx-xx (Rev x.x)
www.omnexcontrols.com
call toll free: 1-800-663-8806
Troubleshooting Guide (con’t)
Chart #2
What is the state of
the lights?
Active light and
Battery light flashing
alternately
Low Battery—Change Batteries
Note: Low batteries will last ap-
proximately 8 hours once the Low
Battery light begins to flash.
Replace batteries during next
break.
Battery light flashes
for 10 seconds then
both lights are OFF
Transmitter failure—
send unit in for service
Test the Transmitter—T110
Turn off the receiver
Ensure there are good batteries in the transmitter
Turn on the transmitter
OK state:
Active light—steady for
about 3 seconds then
goes to fast flash.
Battery light—OFF
Go to
Chart 3
Press one of the buttons
Does the Active
light go to solid
YELLOW?
YES
Does the Active
light go to solid
YELLOW?
The transmitter may be in secure mode (this
will only be the case if the transmitter has been
programmed for the secure mode feature)
To check for this follow these steps:
1. Turn
off
transmitter
2. Turn on transmitter
3. Press these buttons in order:
•
3, 1, 4, 2, ON (Green)
4. Press anyone of the buttons
YES
NO
Reconfigure the transmitter to
ensure it is out of secure
mode
Refer to the Installation / Con-
figuration manual for
directions.
NO
Complete the following steps in order:
1. Check
battery
orientation
2. Clean battery contacts
3. Check or Replace batteries
4. Send in for service
Stuck button:
1. Toggle the buttons a few times
2. If condition persists, send the
unit in for service
Neither light comes
on at any time
Both the Active light
and the Battery light
flash at the same
time
1
3
2
4
ON
