7
DMAN-xxxx-xx (Rev x.x)
www.omnexcontrols.com
call toll free: 1-800-663-8806
Download ID Code
(Use in case of Link Test failure)
Light Legend
Solid
Slow Flash
Fast Flash
Red Light
Green Light
Yellow Light
Follow these steps to download the transmitter’s unique ID Code into the receiver. This will allow the receiver to establish
a radio link with that transmitter.
Refer to the
Light Legend
below for diagram details. Refer to
Troubleshooting Chart #4
for Tips and Considerations
NOTE: It is necessary to download the ID Code when replacing either the transmitter or the receiver.
The cap is held on by two plastic tabs at
opposing sides, which can be unlatched as
shown using a screwdriver. Once the cap
is free, the R130 can slide open.
Use a small slotted screwdriver to press the
Side Tabs inward.
1. Opening the R130 Case
ESTOP FAULT LINK STATUS
A. Supply power to the receiver. The
(E-Stop) light and the (Link) light will
come on RED and the (Status) light
will come on GREEN
2. Power R130
A.
ESTOP FAULT LINK STATUS
3. Power T110 into Configuration Mode
A. Press and Hold Power [OFF]
B. Press and Hold Power [ON]
C. Release Power [OFF] button
D. Release Power [ON] button
A.
B.
C.
D.
