Cod. 710.0103.01.00 Rev2A – 11.2012
3 - 111
- EN -
Introduction
This manual is an integral part of the dryer you bought, and must remain with the machine even if this will be resold.
It is highly recommended that the qualified*personnel for installation maintenance and/or control will fully comply with the contents of
this manual and the prevention and safety rules in force in the country where the system will be used. In this way, not only the usage of
the machine will be rational, but also the service will result cost effective.
In case your dryer will present any kind of problem, please contact your local authorized OMI distributor.
Please note that, when necessary, the use of original spare parts will ensure efficiency and long duration to your dryer.
Due to the continuous technological evolution, OMI reserves the right to modify the specifications contained in this manual without
giving previous notice.
Symbols and labels used in the manual and on the dryer
or
or
or
Air inlet.
or
or
or
Air outlet.
Read the Operators manual before attempt to start
up the machine and to perform any service
operation on the dryer.
Pay particular attention to components or systems
under pressure.
Pay particular attention to the indications preceded
by these symbols.
Pay particular attention to hot surfaces.
Installation, maintenance, and/or control operations
preceded by these symbols must be performed
exclusively by qualified personnel*.
Pay particular attention to the risk of electric shock.
Condensate drain point.
Rotation direction of the fan.
Pay particular attention to the risk of moving parts
Attention:
Before
performing
any
maintenance operation on this machine, do
not forget to disconnect the electric supply,
to completely discharge air pressure, and
to refer to the Operators manual
- Turn main power switch on position 1.
- Push the ON/OFF button.
- There is a variable delay before the dryer will start after the dryer is turned on, in order to warm
up compressor oil.
* Qualified personnel must be trained and certified in accordance with local laws and regulations.
Warranty
This product is supplied after being regularly tested. It is guaranteed for 12 months from the delivery date. This warranty applies
provided the customer has complied with contract and administrative rules and the machine is installed and used under the instructions
of this manual. The manufacturer agrees in fixing or replacing all parts proved to be worn and faulty at the factory free of charge. Final
decision is left to our “authorized service” technicians. Labor costs are not covered by this warranty and the customer will therefore be
charged with the relative amount. Any liability for direct or indirect damages caused to people due to misuse and improper maintenance
of this product is not included in this warranty. It is limited to operation and manufacture defects. All parts subject to wear due to their
specific use are not covered by this warranty. All transport, on-site, disassembly and reassembly costs due to our technician’s
intervention are not covered by this warranty and the customer will therefore be charged with the relative amount if defects are not
under our liability.
Summary of Contents for ED Series
