6-4
Repeater Mounting and Installation
5
On your receiver, there is only one antenna. This must also be replaced with a
High Gain Antenna in order for the range to be increased.
Figure 6-4. Receiver Antenna
Once you have replaced both antennas, the range increase is complete.
In order for the system to work properly, you must use a High Gain Antenna on
both the repeater and the receiver.
Use of any other antenna than what’s supplied with your device will void all FCC
and CE regulatory compliance.
Additional Information on installation and system operation can be found in
Section 6.
NOTE:
NOTE:
RECEIVING
ANTENNA
5-12 Vdc
OMEGA ENGINEERING, INC.
Stamford, CT 06907
omega.com
-
+
!
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference;
2) This device must accept any interference received,
including interference that may cause undesired
operation.
FCC ID: MCQ–XBEEXSC
IC #1846A–XBEEXSC
®
PWR
USB
TX
RX
SB
UWTC SERIES
WIRELESS RF RECEIVER
ANTENNA
915 MHz
Summary of Contents for UWTC-RPT1
