Omega UWTC-RPT1, User Manual

Page: 24 / 44

6-1
Section 6 – Repeater Mounting and Installation
6.1 Mounting
Mounting ears are built-in to your repeater enclosure The diagram below shows
dimensions and mounting hole location. Rubber bumpers have also been
supplied with your repeater should you wish to use the device on a desk or a
work bench next to your PC.
When mounting your repeater, care should be taken to make sure it is as far
away from any metal objects. If nearby metal gets too close to your repeater's
antennas, it has the potential to interfere with the way the unit receives and
transmits data and may cause signal lose or possibly even the inability to
communicate at all with your other devices.
Figure 6-1. Mounting Dimensions
Repeater Mounting and Installation
6
!
64mm (2.5")
89mm (3.5")
76 (3.0)
MOUNTING HOLE
CENTER LINE
Ø3.6 (0.140)
Ø7.5 (0.295)
DIMENSIONS mm (in)
R
UWTC SERIES
WIRELESS RF RECEIVER / REPEATER
OMEGA ENGINEERING INC. omega.com
IC #1846A-XBEEXSC
TX
RX
PWR
SB
Stamford, CT 06907
USB
FCC ID: MCQ-XBEEXSC
5-12 Vdc
ANTENNA
+ -
ANTENNA
RECEIVE
IC #4214A-XBEEPRO
FCC ID: OUR-XBEEPRO
TRANSMIT
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions;
2) This device must accept any interference received,
including interference that may cause undesired
TRANSMIT: 915 MHz
1) This device may not cause harmful interference;
operation.
RECEIVE: 2.4 GHz