4-2
Section 4.1.1 Configure Your Receiver (UWTC-REC1-915)
To complete this procedure your UWTC-REC1-915 receiver must be connected to
a USB port on your PC. Open TC-Central Software and select "Configure
Receiver" from the TOOLS menu.
RF Network Settings:
RF Channel
This setting determines the operating channel on which RF connections are
made between the transmitter, repeater and receiver. The repeater must be set to
the same channel as the transmitter and receiver in order for them to
communicate.
Network ID
This sets the ID of the Network that the transmitter will be joining. It must
match the setting of the receiver in order for them to communicate.
Receiver Address
This sets the destination address for RF packets sent by the transmitter. It must
match the address of the receiver in order for them to communicate.
It is possible to have multiple RF networks operating in the same vicinity. Each
network must have at least one unique RF Network Setting in order to differentiate
the networks.
Figure 4-3. Configure Receiver Screen
NOTE:
Receiver Setup
4
Summary of Contents for UWTC-RPT1
