Connector Operation
4
4-6
If you have not already placed your connector/transmitter into the “Setup”
mode you should do this now before continuing. After your unit has been
placed into the “Setup” mode click the “Next >” button to proceed and
continue setting up your connector/transmitter.
After successful communication between your connector/transmitter has been
established you can click the “Next >” button to proceed and continue setting
up your connector/transmitter. If you did not receive this confirmation of
proper communication you should click the “Back” button to try connecting
again. If you still do not obtain a good connection visit the “Troubleshooting”
Section of this users guide for additional help.
Figure 4-7.
Setup The
End Device
Screen
Figure 4-8.
Establish A
Link Screen
