4-4
Connector Operation
4
RF Channel:
Sets the channel number used for transmitting data to the receiver. Can be set
in the for any value from 12 to 23.
Network ID:
Sets the ID of the network for the corresponding receiver.
Receiver Address:
Sets the address of the corresponding receiver.
STEP 1. Enter the “SETUP” mode.
To place your connector/transmitter into the “SETUP” mode for programming
follow this procedure.
Figure 4-3. Setup Mode
Press and hold the “ON/OFF” button. While the “ON/OFF” button is being
held, press the “SETUP” button one time and then release the “ON/OFF”
button. The green (TX) indicator on the front of your device should be blinking
at a steady rate. This indicates your connector/transmitter is ready to run the
configuration utility software.
STEP 2. Launch Setup Utility Program.
To launch the End Device Configuration Wizard. program on your PC begin
by accessing the “Programs” list under your “Start Menu”.
Scroll through the list of to find the “TC-Central” folder, then select the End
Device Configuration Wizard.
®
TX
UNIVERSAL WIRELESS THERMOCOUPLE CONNECTOR
LOW BATT
PRESS
SETUP
PRESS
ON/OFF
UWTC
SETUP
BUTTON
ON/OFF
BUTTON
Figure 4-4.
Launch Setup Utility Program