4
Configuring The Meter
32
4.12 USING OUTPUT SCALE AND OFFSET (OT.S.O)
Output Scale and Offset (“
OT.S.O”
) scales your analog output to be equal to the meter's
display and/or any engineering units you require. You may scale the output for direct
(4-20 mA, 0-10 V, etc) or reverse acting (20-4 mA, 10-0 V, etc).
1.
Press the
MENU
button until the meter shows “
OT.S.O
”.
2.
Press the
T/mV
button. The meter shows “
RD 1
” (Read 1).
This is your first point of display reading.
3.
Press the
T/mV
button again. The meter shows the last stored Low pH number
with flashing 4th digit.
4.
Press the
/pH
button to change the value of Read 1.
5.
Press the
T/mV
button to scroll to the next digit.
6.
Repeat steps 4 and 5 until the desired value is selected.
7.
Press the
MENU
button to store your selection. The meter shows “
OUT.1
” (Output
1) (Low output).
8.
Press the
T/mV
button. The meter shows the selected output.
If you select “
O.2=V
” for voltage, the maximum signal you may select is
10.00 for an 0-10 Vdc signal output. If you select “
O.2=C
” for current,
the maximum signal you may select is 20.00 for 0-20 or 4-20 mA dc
signal output.
9.
Press the
/pH
button to enter the Output 1 signal selection. If you continue to
press the
/pH
button, the flashing digit's value continues to change.
10
Press the
T/mV
button to scroll to the next digit.
11.
Repeat steps 9 and 10 until the desired value is selected.
12.
Press the
MENU
button to store your selection. The meter shows “
RD 2
” (Read 2).
This is your second point of display reading.
