9
To Activate the Trunk Release*:
Press & Hold the lower transmitter
TRUNK button for 2 seconds
OPERATE OPTIONAL
TRUNK RELEASE
•
The trunk will be released after 2 seconds, and the Status Light will flash twice. If the
doors are also programmed to unlock with Trunk Release, the parking lights will flash twice
and stay on for 30 seconds, and the horn will chirp 2 times if it is connected.
* Connection of the trunk release may require additional parts, and may not be included in a standard
installation.
Remote Trunk Release
Multiple Vehicle Operation
Car “A” Car “B”
v
v
The MARS transmitter can operate two different vehicles
equipped with MARS systems. The slide switch on the
side of the transmitter is utilized for this- one car can be
operated in switch position “A” and the second car in switch
position “B”.
Transmitters must be coded for multiple vehicle operation-
an easy procedure which is explained on pages 9-10.
The “multi-car” switch on
the side of the transmitter
*
the engine.
The Pink/Black wire can be connected to an available auxiliary output of an existing
Remote Security System, and the unit's remote control may also be used to activate the
remote start operation.
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
12345
12345
12345
12345
12345
12345
12345
12345
12345
12345
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
12
12
12
12
Dash Board
Lights
Control
Module
Parking Lights
Light
Switch
White Wire
Typical Parking Lights Connection
Dimmer
Note: output
polarity is
selectable
Jumper
Parking Lights
The White wire is a programmable output to the
vehicle’s exterior parking lights to visually confirm system operations; +12 Volt or - Nega-
tive output may be selected by the Black jumper next to the doorlock port. Connect the
White wire to the vehicle's 12 Volt parking light circuit as shown in the accompanying
diagrams. The correct wire will show 12 Volts only when the headlight switch is in the
"Parking Light" and "Head Light" positions. This wire can usually be found at the head-
light switch, and various other locations within the vehicle, such as the rear body harness
or firewall connector.
18-Gauge White Wire:
( +/- ) Parking Light Output
Connection Recommended.
32
