Remote Panic & Emergency Flashlight
To Activate Panic*:
Press & Hold the left transmitter LOCK or UNLOCK
button
for 3 seconds
•
The horn will sound*, the parking lights will flash and the doors will lock
or unlock, depending on the transmitter button used. To deactivate
Panic, simply again press either the LOCK or UNLOCK button- Panic stops with either
locked doors or unlocked doors, depending on which button is used.
* Connection of the horn may require additional parts, and may not be included in a standard instal-
lation.
8
THE PARKING LIGHTS
WILL FLASH
THE HORN WILL
SOUND*
**
To Operate the Emergency Flashlight:
Press the transmitter LIGHT
button
•
Pressing this button lights the transmitter’s Cool Blue
LED light brightly without sending a radio transmission.
The flashlight should only be used when needed,
to prolong the transmitter battery life.*
*
* When the transmitter has reduced range, or its LED is dim, replace its battery (size 23A, 12 volt) by
removing the small phillips screw on the back and separating the case halves. Carefully reassemble.
Caution: When such a wire is located, be sure to also test that it is non-rheostated:
While metering the wire, operate the dash light dimmer control. The correct wire will
show no change in voltage when the dimmer is operated. Some vehicles have a parking-
light relay which is triggered by a Negative signal from the headlight switch. In these ve-
hicles, the White wire must be connected after the relay, usually at the Fuse/Junction Block.
Do NOT connect the White wire directly to the vehicle’s headlights. An external relay is
required. Vehicles having a split
parking light system must be diode-
isolated, requiring the use of two
IN4006 diodes:
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123
123
123
123
123
123
123
123
123
123
123
123
123
123
123
123
123
123
123
123
123
Right Side Circuit
White Wire
Light
Switch
Left Side Circuit
Parking Lights
Diode Isolation Of Split
Parking Light Systems
Two IN4006 Diodes.
Control
Module
33
The function of the Orange wire is to provide a 500mA Nega-
tive auxiliary output which may be used to operate a starter motor "Anti-Grind" relay, which
prevents accidental starter grind should the key be turned while the remote starter is in
operation. Additionally, the Orange wire also provides the vehicle immobilizing feature for
the Anti-Carjacking operation. Connection instructions are included with optional starter
interrupt socket and relay.
20-Gauge Orange Wire:
( - ) Anti-Grind Output
Connection If Desired.
