12 of 36
Program Mode
The program mode is used to configure the manometer for
Measure Mode operation. After the
PRGM
key is pressed in
Measure Mode, the top line of the display reads “PROGRAM
MODE”. The bottom line reads “UNITS SELECT”. Press the ▲
or ▼ arrow keys to scroll through the Program Mode to the desired
register. The configurable registers found in the
Program Mode
are
Units Select, Damp Rate Select, User Info Select, Contrast
Select, Sea Level Select, Data Logging, Leak Test and Exit
.
Press the
PRGM
key to select any of these configurable registers.
The manometer can be put into
Program Mode
at any time during
Measure Mode operation by pressing the
PRGM
key. If Lockout
is set, the correct code must be entered when prompted (see the
User Info / Lockout section of this manual for more information on
Lockout).
Summary of Contents for HHP360 Series
Page 1: ......
