• The “DISARM” also shows
“ARM”; to indicate the Armed
or Disarmed status of the sys-
tem. Neither icon is present
when the system is in Valet
Mode.
Controller Icons:
The LCD screen on the controller has various icons which
indicate system status. When the controller is used to operate the system, it receives
back a signal which causes it to chirp (emulating the siren) and display the
appropriate icons. Brief descriptions of the icons are:
The 2-Way Controller
The four system- operating buttons are described on pages 4-7. This section
explains the controller’s icons, and how to program the controller’s features.
• The digit readout is a clock, with AM and PM indication. This readout also
shows how many controllers
and/or transmitters are prog-
rammed to operate the system.
• When “BAT LOW” appears the transceiver’s 1.5 volt AAA battery should be
replaced with a new battery.
• The locked or unlocked padlock (windshield) reflects the locked or unlocked
doors status as last operated by the Excalibur system (certain programmable
features can automatically arm the system, but not lock the doors). Arming
with the controller or transmitter always locks the doors; when disarming they
will unlock unless the system is activated and sounding.
• “VALET” indicates alarm Valet Mode, replacing the “ARM” or “DISARM”
icons. A musical tone occurs when placing the system into Valet Mode.
• The “crossed-out key” icon, on the hood area, only appears when the controller
is used with systems having built-in remote starting. This icon indicates an
aborted remote starting due to a violated safety circuit. The AL-1500-EDP can
• “HOOD/TRUNK” indicates that this vehicle zone is or has been violated. If
associated with the system being activated, the controller also emits chirps,
until any button is pressed. In this case, the icon remains flashing until the
ignition switch is turned on.
• The “3” within a circle appears when the 3rd Channel Output is operated.
• The controller’s chirps and musical tones may be turned off, which makes the
unit vibrate instead; “MUTE” indicates this state.
Page - 17
6) Press and release the “:” button
. Each press of the button changes to
the next melody, note that the LCD screen displays “S” and a numeral, which
is the melody number. When the desired musical tone has been the last one
played
press and release the “P” button
.
OR
press and release the “P” button to scroll back through the features.
7)
The controller will play another musical melody; this is the Stop Melody which
plays when remote start engine run period ends. There are five different melody
choices which can be made.
Press and release the “:” button
. Each
press of the button changes to the next melody, note that the LCD screen dis-
plays a numeral, which is the melody number. When the desired musical tone
has been the last one played, you may
• While the controller programming must be “scrolled” through, programming
mode can be exited at any point within the menu by simply not pressing any
buttons for 12 seconds. The Echo chirps once when it exits programming mode.
leave the controller undisturbed for 12 seconds, until it chirps once
• If the Echo is configured for “MUTE” operation (vibrates instead chirping),
then in programming it will not play the musical melodies. Instead, it vibrates
when the remote start Melody and Stop Melody are accessed for programming.
Page - 20
