1.
Sit in a calm environment for at least 5 minutes prior to testing.
3. Do not stand while testing. Sit in a relaxed position while keeping your arm level with
your heart.
4. Avoid speaking or moving body parts while testing.
5. While testing, avoid strong electromagnetic interference such as microwave ovens and
cell phones.
6. Wait 3 minutes or longer before re-testing.
7
. Test comparisons should only be made when monitor is used on the same arm, in the
same position, and at the same time of day.
9. This blood pressure monitor is not recommended for people with severe arrhythmia.
10. Do not use this blood pressure monitor if the device is damaged.
Avoid eating, exercising, and bathing for 30 minutes prior to testing.
2.
. Try to measure your blood pressure at the same time each day for consistency.
8
1. Install batteries
2. Insert cuff air plug into the left side of monitor unit. (See Figure B)
. (See Figure A )
3. Remove thick clothing from the arm area.
4. Rest for several minutes prior to testing. Sit down in a quiet place, preferably at a desk
or table, with your arm resting on a firm surface and your feet flat on the floor.
(See Figure C )
5. Apply cuff to your left arm and keep level with your heart. Bottom of cuff should be
placed approximately 1-2cm (0.4-0.8'') above elbow joint.
(See Figures D&E)
1-2
cm
''
(0.4
-0.8
)
Battery Installation
Slide battery cover off as indicated by arrow.
Install 4 new AAA alkaline batteries according to polarity.
Close battery cover.
AC adapter jack
AC adapter jack is on the right side of the monitor. Medical AC adapter(DC 6.0 V, 600mA)
can be used with the device (recommended, not provided). The adapter connect pin should
be positive inside and negative outside with a 2.1mm coaxial joint.
Do not use any other type of AC adapter as it may harm the unit.
Time/Date Setting
Figure C
Figure A
Figure B
Figure D
Figure E
6. Press
Button to start testing.
"START/STOP"
With power off, press
“
”
about 3 seconds to set the Time/Date mode.
Set month first by adjusting the
“
MEM
”
button, Press
“
STOP/START
”
button to set the
day, hour, and minute in same way.
No matter in which setting mode, press“START/ STOP”button to turn the unit off.
All information will be saved.
Note: if unit is left on and not in use for 3 minutes, it will automatically save all
information and shut off .
START/STOP button
M
D
ST ART
ST OP
MEM
SYS
mmHg
DIA
mmHg
PULSE/min
m
m
H
g
S Y
S
D
IA
m
m
H g
PL
US
E
/m
i n
ME
M
S T O
P
S TA
R T
Important Testing Guidlines
Quick Start
Unit Operation
Unit Operation
7
8
9
10
