3
!
Figure 1 - 21022 Nomenclature
Rear Caster
Front Wheel
Saddle
Handle Sleeve
Oil Filler Plug
(located on Reservoir)
2-Piece Pump Handle/
Release Valve
Lift Arm
PREPARATION
Assembly
(ref. Fig. 1, 2)
1. Assemble the 2-piece handle with provided bolt.
2. Insert handle into the handle socket. Tighten the bolt on handle socket to prevent accidental removal of handle
while in use.
WARNING:
Do not lift or carry jack by the Pump Handle. Pump Handle could dislodge and jack fall, resulting
in possible injury or property damage.
Before Use
1. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product and its components, and recognize the hazards associated with its use.
2. Verify that the product and application are compatible, if in doubt contact Omega Tech Service (888) 332-6419.
3. To familiarize yourself with basic operation, locate and turn the release valve (pump handle):
a.
Clockwise
until firm resistance is felt to further turning. This is the ‘
CLOSED
’ release valve position used to
raise the saddle.
b.
Counter-clockwise
, but no more than 1/2 turn from the closed position. This is the ‘
OPEN
’ release valve position
used to lower the saddle.
4. With saddle fully lowered and release valve closed, pump the handle. If lift arm responds immediately, jack is
ready for use. If jack does not respond, follow
Bleeding/Venting Trapped Air
instruction below.
5. Ensure that jack rolls freely. Raise and lower the unloaded saddle throughout the entire lifting range before putting
into service to ensure the pump operates smoothly. Replace worn or damaged parts and assemblies with Omega
authorized replacement parts only.
Bleeding/Venting Trapped Air
With the release valve in the OPEN position (Step 3b. above) and with saddle fully lowered, locate and remove the
oil filler plug. Pump handle 6 to 8 full strokes. This will help release pressurized air which may be trapped within the
reservoir. Reinstall the oil filler plug and check operation.
