Page 6
Troubleshooting
Blade seems to be cutting slowly or not cutting at all?
Suggestions:
Make sure the blade is mounted to spin in the proper
direction (See Spin Direction, on guard and on blade).
The material being cut may have “loaded” or “glazed” the diamond.
Use a dressing stone or “green stone” to free the diamond. See video on
https://omegadiamond.com/ExposingDiamondSharpenDressBlade_Vide
o
Blade binds or “freezes.”
Suggestions:
The blade may be cutting at a slight angle. Check
alignment. Make sure that the saw is rolling freely on the rails and the
rails are not damaged or bent. Make sure that the blade spindle is
securely fastened to the mounting plate.
Saw shuts off after a few minutes of use and/or fails to turn
on at all.
Suggestions:
Check circuit breaker. If that is on and it still fails to
start, the motor may have overheated and may need to be replaced.
Also check the brushes in the motor. If these are worn out you can
either order them from us, directly from the motor manufacturer, or pick
them up from your local hardware store.
Saw grinder motor spins but blade dose not turn.
Suggestions:
Check if timing belt is broken. Replace if needed.
If you have any questions please call us toll free:
1 (888) 996-4777
Summary of Contents for Blue Ripper G2
Page 8: ...Page 8...
