Page 3
Operating Instructions
Installing/Replacing Blade:
Note:
This saw is designed for stone and masonry applications
exclusively. For optimal performance use only Diamond blades from
Omega Diamond that are designed for the material you are cutting.
Place the saw on the rail (with rail rubber side down) providing
clearance for installing the blade. Loosen Vertical Adjustment lock and
raise motor to full height.
Remove the right-hand threaded bolt that is holding the flanges and
blade to the shaft, by turning counter clockwise. If the bolt is too tight to
loosen by hand, use a 8mm Allen wrench to turn it. (To lock the shaft,
insert a #2 Philips screw driver through the hole and shaft in the motor
mount housing.)
Remove the front flange (and old blade, if applicable) and slide the
new blade against the rear flange. Ensure that the blade is flat against the
rear flange with rotation direction arrow facing counter-clockwise.
Arrow on some blades may be facing the motor or facing out, depending
on blade manufacturer (see Spin Direction, pg 6).
Replace the front flange so the blade is sandwiched between the two
flanges. Replace the right-hand threaded bolt and tighten securely by
hand.
For more detailed instructions see YouTube video
https://www.youtube.com/watch?v=Jn7QugM0NCg
Summary of Contents for Blue Ripper G2
Page 8: ...Page 8...
