omega altise
Water Drainage
When the water tank is full, the
WATER FULL
indicator will illuminate
and the compressor will stop working. A buzzer will sound Pressing
any button will stop the buzzer. You will need to empty the water tank
before the unit will work again.
Before you empty the unit you will need to:
1. Turn the unit off and pull the plug out of the power supply.
2. Place a water tray or pan under the drainage port.
3. Remove the drain knob and rubber plug on the drainage port and
drain into the tray beneath.
4. Once drained, replace the rubber plug and drain knob into the
drainage port and tighten by hand.
5. Plug the unit back in and switch it on. The compressor will delay
restarting for three-minutes and then continue to work as normal.
Fig. 8
Important! It is recommended that you do not move the unit around without firstly draining
the internal tank. If water is left in the unit then it may spill out onto the floor or carpet.
Continuous Drainage
If you wish to operate the unit without the need to
empty the water tank, please:
1. Turn the unit off and pull the plug out of the power supply.
2. Remove the drain knob and rubber plug on the drainage
port and retain for future use.
3. Connect the drain tube supplied to the water outlet as
shown and locate the other end into a drain.
4. The drain tube may be extended by using a suitable
connector and an extension tube (OD: 18mm).
5. Plug the unit back in and switch it on. The compressor will
delay restarting for three-minutes and then continue to
work as normal.
Fig. 9
Please note:
1. The drain must be at or below the outlet level
2. Flashing comp/ ‘water full’ indicator will not function in this mode of drainage.
3. When the room humidity is over 85%, it may be necessary to utilise the continuous drainage method.
12
