Omcan J-110, Instruction Manual, Page: 9 / 20

9
Maintenance
1. ALWAYS TURN OFF AND UNPLUG YOUR JUICER BEFORE SANITIZING.
2. Prepare / use a certified sanitation solution that is food grade compliant. Always follow the directions on the
container.
3. Assemble the machine, leaving the top off. Make sure the blade nut is tightened.
4. Wrap the base in plastic wrap cover the power switch and power cord. Set waste container under the juice
pan spout. Spray approximately 1 pint of the sanitizing solution around the perimeter of the filter screen,
inside the filter screen, and onto the cutter plate and blade nut. Once done, remove the plastic wrap and
thoroughly dry the base.
5. Thoroughly clean latch assembly, with particular attention to the adjustment thread.
6. Replace the top. Lock latches. You should hear an audible SNAP sound when properly adjusted.
7. Insert the pulp pipe into the pulp spout of the lid.
8. With receptacles under the juice spout and pulp pipe, spray 1 quart of sanitizing solution down the feed
chute while the juicer is running. Follow by rinsing the sanitizing solution from the juicer by spraying one
quart of clean water into the feed chute while the motor is running. Allow the juice pan to drain. Dispose of
the waste solution.
9. Clean the pusher with sanitizing solution and rinse thoroughly.
10. Test before use. Before use, check to make sure all the parts are in proper alignment. Plug your juicer into
an electrical outlet and test before use. The juicer is now ready for operation.
NIGHTLY CLEANING
Scrub the filter with steel wool to remove any loose pulp before washing the parts with hot soapy water. Make
sure the screen holes in the filter are clear before assembly, if not, scrub again with soap and steel wool pad,
rinse and assemble as instructed on page #5.
ATTENTION: IMMERSING, SPRAYING, OR HOSING THE POWER UNIT WILL VOID YOUR WARRANTY.
Do not immerse or spray the base and tower sections of the unit with water or other liquids. The base, motor
housing, and tower sections should only be cleaned with a damp cloth or sponge. It is important that the rims
of the tower and top be wiped thoroughly before assembly. Never spray or wash the exposed shaft of the
machine. The motor and electrical parts of the machine are not waterproof. Contact with water or other liquids
will damage the motor, bearings, and electrical system.
MAINTENANCE CLEANING DURING THE DAY
If you are using the juicer intermittently, pulp residue may collect and dry on the filter. This may cause
vibration during use. To prevent this vibration, remove the filter after more than one half-hour of idle time, and
rinse it under hot water. Before reassembling, make sure all holes are free of any pulp residue. PROPER
CARE OF YOUR FILTER IS ESSENTIAL. Your filter is engineered to provide the finest juice possible. It is
constructed with very fine stainless steel, and has been precisely balanced to provide vibration free operation.
Proper cleaning and handling are necessary to ensure the best possible operation of your juicer. LATCH
ADJUSTMENT. The threaded latches on your machine may need future adjustment. The latches should
require some pressure when putting the lid on the machine. You should hear an audible SNAP when properly
adjusted.