Omcan J-110, Instruction Manual, Page: 11 / 20

11
Troubleshooting
Motor stops while juicing. Loss of power to machine. Turn OFF and UNPLUG.
Check circuit breaker.
Check plug at outlet. (Check the
outlet by plugging something else
into it).
Overheating (if switch is in the ON
position and light is on).
Turn OFF and UNPLUG. Reset
manual overload button after
machine cools.
Switch damaged. Turn OFF and UNPLUG.
Call Omcan for replacement
switch.
Excessive vibration. Pulp sticking to filter. Filter dented or damaged, replace
filter.
Filter Discolored (brown color),
clean filter thoroughly, soak
overnight in Clean Cut solution.
Latches loose, tighten latches by
turning clockwise. Ensure even
tension on both sides.
Latch tension uneven; adjust to
ensure even tension on both sides.
Dull cutter plate, needs
sharpening.
Cover rattles or latches come
undone.
Loose latches. Adjust and or tighten latch arms.
Pulp is too wet. Holes in filter are clogged. Clean filter (see instructions for
Clean Cut).
Dull cutter plate. Sharpen cutter plate.
Pulp does not exhaust, but no
vibration problems.
Clogged discharge opening. Clean out pulp discharge pipe.
MOTOR RESET PROCEDURE
The motor has an automatic safety shut-off to avoid overheating. When it detects an overload, it automatically
cuts off the power. It will not reset itself. There is a manual reset push button on the base of the motor. If your
machine turns off while in use, allow the machine 15 minutes to cool. To reset, switch OFF the machine and
UNPLUG cord from outlet. Disassemble machine per instructions on page 6. Turn the machine upside down so
it is sitting on the tower. The red reset switch on the bottom of the motor is accessible through the hole on the
base screen. Firmly push on the red switch (you may hear an audible CLICK sound. Turn the machine upright
and reassemble per instructions on page 5. If the machine stalls again, contact Omcan at 1-800-465-0234.