Omcan J-110, Instruction Manual, Page: 6 / 20

6
Assembly and Disassembly
Operation
11. Clean the pusher with sanitizing solution and rinse thoroughly. The juicer is now ready for operation.
12. Test before use. Before use, check to make sure all parts are in proper alignment. Plug your juicer into a
grounded electrical outlet and test before use.
DO NOT PLUG MACHINE INTO AN ELECTRICAL OUTLET UNTIL ASSEMBLY IS COMPLETE. Wear vinyl
gloves (as used in food handling) during operation.
DISASSEMBLING YOUR OMCAN COMMERCIAL JUICER EXTRACTOR
1. TURN OFF AND UNPLUG JUICER. Make sure the motor and cutter plate have completely stopped before
disassembling. Disconnect the pulp ejection pipe and remove the food pusher.
2.
UNLATCH AND REMOVE TOP.
Release the top latches by pulling them away from the machine. Make
sure to release both latches at the same time to maintain equal tension. Carefully lift the top straight up. Be
sure it does not touch the screen filter. Place the top upside-down on a flat, stable counter top.
3. STABILIZE THE FILTER. Place your left arm across the top of the filter, and grip the far side of the filter rim
with your fingers. Hold the filter steady by applying equal pressure with your forearm and hand.
4.
UNSCREW AND REMOVE THE BLADE NUT.
With your right hand, place the head of the wrench on the
blade nut. Turn the blade nut counter-clockwise while holding the filter steady with your left arm. To remove
the blade nut, use only the special wrench provided with your unit. Always wash the wrench between uses.
NEVER leave the wrench on the blade nut unattended.
5. REMOVE JUICING PARTS. With both hands, carefully lift the filter and cutter plate from the juice pan.
Carefully insert your index finger into the center hole of the cutter plate, and lift it out of the filter. The cutter
plate blades are sharp, so handle carefully. EXTRA CARE MUST BE TAKEN SO THE FILTER IS NOT
DAMAGED WHEN DISASSEMBLING OR REASSEMBLING THE MACHINE.
6. REMOVE THE JUICE PAN. With both hands, lift the juice pan out of the tower and set it upside-down on a
flat, stable counter top.
1. Ensure the machine is fully assembled.
2. Plug it in.
3. Place the juicing container below the juice pan spout.
4. Make sure there is a receptacle for pulp waste under pulp pipe.
5. Turn ON the machine.
6. Insert prepared produce in the feed pipe.
7. Use the Food Pusher to guide produce through the feed pipe. Do not force. While juicing, make sure pulp
is being ejected through the pulp pipe.
Note: (Please be advised that the J-110 Juicer has been designed as a production juicer; meaning that it is
not suitable for single glass portions. It is designed to produce 3 to 4 quarts of juice at a time. The centrifugal
ejection of the pulp requires some mass (weight), in order to be expelled from the filter. It is normal not to see
pulp being expelled at the beginning of the juicing process. Continue to feed the juicer with product and when