8
Operation
CONTROL DEVICES
On the front (Fig. 4):
• GREEN key Starting.
• RED key Stopping.
• GREEN indicator Machine running.
FUNCTIONAL TEST
The machine is ready for the functional test once the plugs have been plugged into the mains socket.
Starting:
Press the green key; the indicator lights up and the machine starts.
Stopping:
Press the red key; the machine stops and the indicators turns off.
Start the machine without any load for 1 minute to make sure it is working properly. Before starting a new work
cycle, make sure that the machine is perfectly clean, especially the surfaces that come into contact with the
dough. If necessary, clean as per the instructions in the Maintenance section.
USING THE MACHINE (FIG. 3)
• Press the GREEN key. The machine starts the two pairs of rollers moving and is now ready to work.
• Before putting the ball of lightly floured dough into the opening of the top protection, which has been left to
rise for at least 4-6 hours, make one edge of the dough into a wedge to help it slip in between the pair of
top rollers (3).
• When it comes through these rollers the dough will have been made slightly thinner (S) and oval in shape
then, sliding along the balancing device it turns crosswise about 90° (4) ready for the next passage through
the pair of bottom rollers (5) from where it comes through in the shape of a disc (6) whose shape, good but
not optimum, needs a little adjusting by hand.
STOPPING THE MACHINE
• Press the RED key.
USING THE PEDAL CONTROL
The pedal control is supplied only on the customer’s request.
Its use, which integrates the front controls for starting and stopping, is to keep the machine working only for the
time strictly necessary to do the job.
•
This control is to be connected to the machine by plugging the cable plug into the machine’s socket.
Starting
•
By pressing the green key the machine starts but remains in the waiting mode.
•
By pressing the pedal control slightly the rollers start turning and the machine is ready for use.
Stopping
• Lift your foot off the pedal control and the machine stops.
WARNING: Press the red key when the working phase is finished.
