Omcan 59020, Instruction Manual

Page: 17 / 48

17
Maintenance
NOTES
• After removal of the wires, check the strips of fiber glass for damage; replace if necessary.
• Check the condition of the tensioning springs at both ends of the seal beam; replace if necessary.
• Using the seal beam without the springs may cause the sealing wires to break.
• Check contact plate for damage; replace if necessary.
INSTALL THE SEALING AND CUTTING WIRES AS FOLLOWS:
1. If necessary, install new strips of fiber glass on the seal beam.
2. Insert the new wires behind one of the mounting plates and tighten the screws; make sure that the end of
the wires line up with the bottom edge of the mounting plate.
3. Position the wires across the seal beam and loosely install the second mounting plate.
4. Carefully clamp the seal beam upside down in a bench vice.
5. Pull the wires as tightly as possible with a pair of pliers and secure the second mounting plate by tightening
the screws.
NOTE
1. The wires can be further tightened by slightly loosening the screws of one of the mounting plates.
2. Pull the wires one-by-one tighter with a pair of pliers.
3. Re-tighten the screws after the correct tension has been achieved.
4. Cut the end of the wires flush with the bottom edge of the mounting plate.
5. Apply the Teflon tape smooth and tight over the seal beam without creases. Make sure that the beam is
clean and free of grease.
6. Re-install the seal beam in the vacuum chamber and re-connect the wires.
ALUMINUM T-SHAPED SEAL BEAM
REMOVE THE SEALING WIRES AS FOLLOWS:
1. Remove the seal beam from the machine.
2. Remove the Teflon tape.
3. Loosen the screws on both sides of the beam; this will release the sealing wires.
4. Clean the seal beam thoroughly.
INSTALL THE SEALING WIRES AS FOLLOWS:
1. Apply new fiber glass to the beam if necessary.
2. Place new wires on the beam and fasten them on one side with mounting plates; tighten the screws.
3. Position the wires across the beam.
4. Fasten mounting plates; tighten screws.
5. Carefully clamp the beam in a bench vice.
6. Pull the wires as tightly as possible with a pair of pliers.
7. Secure the mounting plates with the screws.
NOTES
• Check the strip of fiber glass for damage and replace if necessary.
• Check the springs and replace if necessary.
• Using the seal beam without the springs may cause the sealing wires to break.