Omcan 59020, Instruction Manual

Page: 9 / 48

9
Operation
Service Symbol:
• After a number of operating hours or packing cycles, the service symbol will briefly appear on
the display when the machine is turned on. In addition, the display indicates how many hours
or cycles remain before an oil change is required.
• Except for regularly changing the oil in the pump (important!), the machine requires little other
routine maintenance.
• To reset the service interval counters after the oil change: Start machine and while the
display shows the hours or cycles, press and hold the button.
TEN-PROGRAM CONTROL SYSTEM
In addition to vacuum and sealing times, Henkovac machines with a Ten-Program control system may be
programmed for several additional functions. Each of the 9 customizable programs is either:
1. Time controlled.
2. Sensor controlled.
TIME-BASED OPERATION (VACUUM GAUGE: MBAR)
• The values for vacuum and sealing time, as well as the values for several optional functions, are selected
by the customer and saved in any of 9 customizable programs P1-9.
• When operating a packaging machine with a time-based program, the actual vacuum pressure is indicated
by the analog vacuum gauge. The number of seconds of vacuum time remaining is shown on the LCD
display.
PLUG AND PLAY
• When turning on a time-based machine for the first time, it will start up in the PA program AUTOMATIC.
This is a pre-set factory program with 30-40 seconds vacuum time and 2 seconds of sealing time.
• When turning on the machine after that, it will start up in the most-recently used program.
OPTIONAL INSTALLATION OF A SENSOR OR SOFT-AIR
• A machine with a time-based control program can be upgraded to sensor-based operation at a later date
by installing the optional sensor kit.
• The Soft-Air feature can also be installed at a later date by ordering the optional soft-air kit.
SENSOR-BASED OPERATION (DIGITAL DISPLAY: MBAR)
• When operating a packaging machine with a sensor-based program, the actual vacuum pressure is digitally
shown on the LCD display in mbar (standard setting) or in % vacuum.
PLUG AND PLAY
• When turning on a sensor-based machine for the first time, it will start up in the PA program AUTOMATIC.
This is a pre-set factory program with 5 mbar of vacuum and 2 seconds of sealing time.
• When turning on the machine after that, it will start up in the most-recently used program.
OPTIONAL INSTALLATION OF SOFT-AIR
• The Soft-Air feature can also be installed at a later date by ordering the optional soft-air kit.