Preparation for Use
MOBILE WORKSTATION WM-DP1
19
2.
Referring to Figure 4.9, pull out the finger grip on the lower index plunger and rotate it 90°,
the arm is now free to rotate. Rotate the arm until parallel with the top tray as shown.
3.
Remove the M8 screw to separate the MAJ-181 restrictor assembly.
4.
Referring to Figure 4.10, secure the MAJ-181 restrictor - front to the MAJ-181 restrictor - rear
through the uppermost hole in the monitor arm using the M8 coil washer, M8 plain washer
and M8 x 50mm screw. Fully tighten the screw using the M6 A/F Allen key supplied.
NOTE
The monitor arm must be parallel to the top tray to ensure the tag on the
monitor arm aligns with the cutout in the restrictor (Figure 4.10 inset).
Figure 4.8
Figure 4.9
to disengage
Rotate arm
MAJ-181
Index plunger
Top view
